Help

 

Set up a new Vibio


You need to set up your Vibio before you can start using it. Follow the easy steps below:

Charge your Vibio

  1. Plug the charging cable into the USB port on your computer or use a USB power adapter with max 12W output. Plug the other end into the Micro USB port on the side of your Vibio.

  2. The LED’s will blink in green during charging. When your Vibio is fully charged, the LED’s will stop blinking.


Turn on your Vibio

  • Slide the On/Off switch to the right and keep your Vibio close to your mobile phone.


Pair your Vibio

Pairing makes sure the bed shaker and mobile phone can communicate with one another.

  1. Pull and hold the Snooze strap until the LEDs starts to flicker. Release and pull it again until the LEDs starts to breathe in blue.

  2. Open the Vibio app, tap Setup Vibio and follow the simple setup instructions.

  3. The LED eyes on Vibio will light up in blue 4 times to show that the pairing was successful.


Tuck in your Vibio

  • Slide your Vibio under the mattress or pillow and make sure the snooze strap is easy to reach. Now you are ready to set your first alarm!

Interpret the LED eyes


Your Vibio is equipped with two LED eyes that are located on the top front.

Here is how you interpret the LED color:

White
This means that Vibio is activated by an alarm or communicating with your mobile.

Blue
This means that Vibio is ready for pairing.

Green
This means that Vibio is charging.

Yellow
This means that you have an incoming call or message.

Red
This means that the battery level is low.
The LEDs are also red during software updates.

Check the connection


You can always check the connection by looking at the Vibio icon on the top right corner of the app home screen. If it’s displayed normally, Vibio is connected. If it’s crossed out, the connection is lost.

Note: The connection will be automatically re-established when Vibio is within Bluetooth range.

Pair your Vibio


When you open the Vibio app, Vibio should connect to your mobile phone automatically, as long as it’s within Bluetooth range. If it doesn’t connect, you might need to pair Vibio manually.


To pair your Vibio manually:

  1. Open the Bluetooth menu on your mobile phone and remove “Vibio” from the unit list. Pull and hold the Snooze strap until the LEDs starts to flicker. Release and pull it again until the LEDs starts to breathe in blue.

  2. Open the Vibio app. Tap to open the Menu, select Setup a New Vibio and follow the simple setup instructions.

  3. The LED eyes on Vibio will light up in blue 4 times to show that the pairing was successful.

Note: You can always check the connection by looking at the Vibio icon on the top right corner of the app home screen. If it’s displayed normally, Vibio is connected. If it’s crossed out, the connection is lost.

 

FURTHER HELP

Customer support